Lang ECOH-PP - Daily Operation Guide; Step-by-Step Daily Operation

13
Daily Operation
Step 1: Turn the Power Switch on by switching
the toggle switch to the up position.
Step 2: Screen will appear as below.
Select the product you wish to bake by pressing
the number key (0-9) for that product.
Step 3: Screen will display:
When the oven reaches the desired temperature,
the screen will display:
Step 4: Open the oven door, place product in the
oven. Close the oven door and press the
program key you are using.
Step 5: The display will now read:
Press the lettered keys indicating what shelves
you placed product on to bake
(A is the top shelf).
SELECT PRODUCT OR
READ/CLEAR TO PROGRAM
XX:XX PM XXX F
IL1459
PRODUCT 1
PREHEATING TO XXX F
XX:XX PM XXX F
IL1460
READY
SELECT PRODUCT TO START
XX:XX PM XXX F
IL1461
SELECT OVEN SHELVES
PRODUCT 1
XXXF XX:XX:XX
XX:XX PM XXX F
IL1462
NO SHELF SELECTED
PRESS E TO CONTINUE
IL1463
If you do not select a shelf, the oven will beep
and the following display will appear:
Press the E Key and the previous display will
appear, again asking to select oven shelves
Step 6: Once a shelf or shelves have been
selected, the display will now read:
At this time, you may select any other pre-set
product program which has the same oven
temperature. A lighted red light next to a
numbered product key indicates that the
program is compatible with the program
selected, and can be run at the same time.
Step 7: When the bake time is concluded, the
oven will beep and the display will read:
Step 8:
Once you have completed baking on
one pre-set program, you may change to another
pre-set program by pressing the Read/Clear Key.
The display will now read:
COOKING PRODUCT XX
TIER #1 XX:XX:XX
SELECT PRODUCT
XX:XX PM XXX F
IL1462
DONE
PRESS SHELF BUTTON
REMOVE PRODUCT
XX:XX PM XXX F
IL1465
SELECT PRODUCT OR
READ/CLEAR TO PROGRAM
IL1466
DAILY OPERATION PURPLE PLUS
CONVECTION OVENS
ECOH-PP, ECOF-PP, GCOF-PP,
EHS-PP, ECCO-PP, GCCO-PP