To Next PageTo Next Page
Need help?Do you have a question about the LANPARTE LA3D-S and is the answer not in the manual?
General| Brand | LANPARTE |
|---|---|
| Model | LA3D-S |
| Category | Camera Accessories |
| Language | English |
Press the power button to enter standby mode. Signal light turns blue and blinks.
Press M button for 5 seconds to activate, press again to return to standby.
In standby mode, press RIGHT button for 8 seconds to activate inverted mode.
In standby mode, press DOWN button for 5 seconds to restore factory default.
In standby mode, press LEFT button for 5 seconds. Green light blinks until calibration is done.
Specifies the maximum angles for Yaw, Roll, and Pitch axes.
Provides the physical size and weight specifications of the gimbal.
Activated by pressing M button once. Locks Roll axis.
Activated by pressing M button twice. Locks Pitch & Roll axes.
Activated by pressing M button three times. Locks Pitch, Roll & Yaw axes.
Align white dots and turn the knob clockwise to connect the grip to the gimbal.
Install smartphone, balance horizontally and vertically using adjustment screws and counterweight.
Gimbal operates at 7.4V. Use a maximum of two 3.7V batteries combined correctly.
Details on 18350 Li-ion battery capacity (900mAh) and charging time (3h).
Details charger input (DC 5V/800mAh) and output (DC 4.2V/400mAh x 2).
Align white dots and turn the knob to connect the grip to the gimbal platform.
Install smartphone, balance horizontally and vertically, adjust using knob.
Unscrew power button and install two 18350 batteries.
Press the white power button to turn the gimbal on.
Use M button (hold, double-tap, triple-tap) to switch between modes 1, 2, and 3.
Set counterweight on left, slide phone left/right for horizontal balance.
Loosen vertical axis screw, move phone forward/backward for vertical balance.
