APPENDIX - WARRANTY
76
9.0 Appendix
CE Declaration of Conformity
Glossary
Warranty
9.1 Glossary
Auto Film Cut-off – This option automatically cuts the film at the end of the wrap cycle.
Banding – This is the number of wraps that the FDS applies to a selected section of the load.
The settings are from 1 to 9.
Bottom Wrap - This sets the number of wraps for the bottom of the load. The settings are from
1 to 9.
Emergency Stop (E-stop) – The E-stop is a red button that safely stops the machine in an
emergency condition.
Film Delivery System (FDS) - This is the Electrical/Mechanical assembly that applies the film
to the load
FDS Carrier – The carrier is the fab that holds the FDS assembly. The assembly bolts to the
carrier.
G Force Plus FDS – This option uses an electric brake to control the tension on the film.
Initialize - This sets the safety circuits and puts all components in the start position
Lockout/Tagout - These procedures make sure that the machine is off and not started up before
you complete the maintenance work.
Mast – The upright that holds the FDS and the control panel
Overwrap – The number of wrap counts at the top of the film above the top of the load.
Pallet Grip – This options locks the load to the pallet.
Pause – This control pauses the wrap cycle then lets you continue without the need to reset the
machine.
Reset - This blue button applies the control power to the machine. It illuminates when the
control power is on.
Settings – The settings are adjustable timers and counters that control the machine operation.
Top Wrap - This sets the number of wraps for the top of the load. The settings are from 1 to 9.
Turntable Top - This is a circular plate that holds the load and turns during the wrap cycle.
Wrap Assist – This option decreases the turntable speed and the film tension. It makes it easy to
“rope” the film and apply cornerboards, top sheets, labels, etc.
To Next Page