3: Command Line Interface
EDS1100/2100 Command Reference 13
Figure 3-2 Login Level Commands
>?
clrscrn enable
exit ping <host>
ping <host> <count> ping <host> <count> <timeout>
show show eds2100
show history trace route <host>
>
To configure the EDS1100/2100, you must be in the enable level and any of its sub-levels. Figure
3-3 shows the enable level commands.
Figure 3-3 Enable Level Commands
>enable
(enable)#?
auto show interfaces auto show processes
clear interfaces counters clrscrn
configure connect
connect line <line> device
disable dns
email <number> exit
filesystem kill ssh <session>
kill telnet <session> line <line>
lpd no clear interfaces counters
ping <host> ping <host> <count>
ping <host> <count> <timeout> ppp <line>
reload reload factory defaults
show show eds2100
show history show interfaces
show ip sockets show processes
show sessions ssh
ssh <optClientUsername> <hos
t>
ssh
<optClientUsername>
<host>
<port>
ssl telnet <host>
telnet <host> <port> trace route <host>
tunnel <line> write
xml
See the Chapter 5: Commands and Levels at the end of this document for a complete list of levels,
commands, and descriptions.
To Next Page
Loading...
Need help?
General