BCP Command Examples Troubleshooting
B-6
server will attempt to reload continuously. If
there is an error, or if the console’s Return key
is pressed, the MSS will re-enter the Boot
Configuration Program.
Change BOOTP {Enabled, Disabled}
Enables or disables the sending of BOOTP
queries during the boot sequence. It is enabled
by default.
Change DHCP {Enabled, Disabled}
Enables or disables the sending of DHCP
queries during the boot sequence. It is enabled
by default.
Change Hardware xx-xx-xx
Specifies the last three numbers of the server’s
Ethernet address. The first three numbers will
be supplied automatically.
The Ethernet address should have been set at
the factory. Setting an incorrect address could
cause serious network problems.
Change IPAddress ip_address
Specifies this server’s IP address. Uses the
standard numeric format.
Change Loadhost ip_address
Specifies the host to attempt to load the file
from. The IP address should be in standard
numeric format (no text names are allowed).
Change RARP {Enabled, Disabled}
Enables or disables the sending of RARP
queries during the boot sequence. It is enabled
by default.
Change Secondary ip_address
Specifies a backup loadhost. The IP address
should be in standard numeric format (no text
names are allowed). The backup loadhost will
be queried if the primary host cannot load the
server.
To Next Page
Loading...
Need help?
General