Updating Software Configuring TCP/IP Reload
D-3
To manually configure the MSS IP parameters for software reload when running
operational software (not BCP mode), use the following commands.
Figure D-2: Configuring TCP/IP Reload
Note:
For instructions on how to log into the MSS to enter these commands,
see the Getting Started chapter.
The path and filename are case-sensitive and must be enclosed in quotation marks. When
attempting to boot across an IP router, you must configure the router to proxy-ARP for the
MSS, or use the bootgateway feature. For more information, see Bootgateway in the
Commands chapter of the Device Server Reference Manual located on the CD-ROM.
D.2.1.2 NetWare
The MSS100.SYS file should be placed in the login directory on the NetWare file server.
The MSS cannot actually log into the file server (since it knows no username/password); it
can only access files in the login directory itself. On the MSS, specify the file server name,
filename, and path.
Figure D-3: Configuring NetWare Reload
D.2.1.3 MOP
The MSS100.SYS filename is the only parameter that the MSS needs to reload via MOP.
Make sure the service characteristic is enabled on the host's Ethernet circuit, copy the
MSS100.SYS file to the MOM$LOAD directory, and reload the MSS using the Initialize
Reload command. Be sure to use binary mode for any file transfers.
Local> SET PRIVILEGED
Password> SYSTEM (not echoed)
Local>> CHANGE IPADDRESS nnn.nnn.nnn.nnn
Local>> CHANGE SOFTWARE “/tftpboot/MSS100.SYS”
Local>> CHANGE LOADHOST nnn.nnn.nnn.nnn
Local>> SHOW SERVER BOOT
Local>> INITIALIZE RELOAD
Local> SET PRIVILEGED
Password> SYSTEM (not echoed)
Local>> CHANGE NETWARE LOADHOST fileserver
Local>> CHANGE SOFTWARE SYS:\LOGIN\MSS100.SYS
Local>> INITIALIZE RELOAD
To Next Page
Loading...
Need help?
General