5: Web and Command Line Interfaces
SLC™ Console Manager User Guide 45
To clear an IP address, type 0.0.0.0, or to clear a non-IP address value, type CLEAR.
When the number of lines displayed by a command exceeds the size of the window (the
default is 25), the command output is halted until the user is ready to continue. To display the
next line, press Enter, and to display the page, press the space bar. You can override the
number of lines (or disable the feature altogether) with the set cli command.
General CLI Commands
The following commands relate to the CLI itself.
To configure the current command line session:
set cli scscommands <enable|disable>
Allows you to use SCS-compatible commands as shortcuts for executing commands.
Note: Settings are retained between CLI sessions for local and remote users.
To start a menu if a menu is associated with the current user and was not displayed at
login:
set cli menu start
To set the number of lines displayed by a command:
set cli terminallines <disable | Number of lines>
Sets the number of lines in the terminal emulation screen for paging through text one screen at a
time, if the SLC console manager cannot detect the size of the terminal automatically.
To show current CLI settings:
show cli
Table 5-1 SCS and SLC Commands
SCS Commands SLC Commands
info show sysstatus
version admin version
reboot admin reboot
poweroff admin shutdown
listdev show deviceport names
direct connect direct deviceport
listen connect listen deviceport
clear set locallog clear
telnet connect direct telnet
ssh connect direct ssh
To Next Page
Loading...
Need help?
General