Need help?Do you have a question about the Lantronix SCS100 and is the answer not in the manual?
General| Ports | Serial |
|---|---|
| Protocols | Telnet |
| Management | Web-based, CLI |
| Power Supply | External |
| Operating Temperature | 0°C to 50°C |
| Network Interfaces | 1 |
Step-by-step guide on how to physically connect the SCS unit to devices and the network.
Details various methods for configuring the SCS after initial setup, including web browser and Telnet.
Methods and procedures for assigning an IP address to the SCS for network communication.
Procedures for setting up dial-up access to the SCS for remote users.
Details on configuring and using SSHv1 and SSHv2 for secure remote access.
How to configure serial port logging and set up email notifications for events.
Methods to increase the security of the SCS, including incoming security and port restrictions.
Guides to diagnose and resolve issues related to the SCS unit's power-up sequence.
Steps to diagnose and fix problems related to BOOTP requests for IP address assignment.
Details on using commands available at the SCS boot prompt for configuration.
Methods for updating the SCS software, including EZWebCon, TFTP, and FTP.
To Next Page