SCS100/200/400 User Guide 3: The SCS200
Note: The Reset button returns the SCS to its factory default configuration when you
press and hold it during the power-up and boot process. Resetting to factory default will
enable DHCP.
Serial Connector Pinouts
RS-232/RS-485 DB25 Connector
The DB25 connector provides a dual RS-232/RS-485 DTE serial port. The default serial
port settings are 9600 baud, 8 bits, no parity, and 1 stop bit.
DB25 Serial Connector (DTE DB25 Male)
RS-232 DB9 Connector
The SCS200 DB9 connector provides an RS-232 DTE serial port. The default serial port
settings are 9600 baud, 8 bits, no parity, and 1 stop bit.
DB9 Serial Connector
PC Card Slot
The SCS200 PC card slot accepts Type I/II PC cards. As of this writing, the SCS200
software supports 16-bit IEEE 802.11 wireless networking PC cards, PCMCIA modem
cards, and ATA flash disks and hard-drive PC cards. New cards may be added.
Note: Changes in firmware releases may affect compatibility.
3-2
To Next Page
Loading...
Need help?
General