SCS100/200/400 User Guide 5: Installation
Assign IP
8. Click the Assign IP... button.
9. Wait for instructions from EZWebCon.
For assistance once EZWebCon is running, refer to EZWebCon's online help.
DHCP Method
If DHCP is enabled on the SCS, the SCS will accept an IP address, gateway address,
and subnet mask from a DHCP host. DHCP can be enabled or disabled with the following
command:
Set/Define Server DHCP [Enabled | Disabled]
DHCP is disabled in production. Resetting the unit to factory defaults via the reset button,
command line, or web interface will enable DHCP. (See page 2-1 for information on
resetting hardware or page 7-4 for information on the Flush NVR command.)
Command Line Method
To assign an IP address to the SCS via a terminal:
1. Attach a terminal to the serial port (port 2) and press Enter. You see a Local>
prompt at which you can enter configuration commands.
2. Once you are connected, become the privileged user and enter the Define IP
IPaddress command.
Note: The default privileged password is system.
Entering IP Address at Local Prompt
Local> SET PRIVILEGED
Password> system (not echoed)
Local>> DEFINE IP IPADDRESS 192.0.1.228
5-4
To Next Page
Need help?
General