SCS100/200/400 User Guide 6: Application Setup
Configuring an Email Site
5. Click the Update button to save changes.
Dial-Out ISP Connection
In some cases, you may require the SCS to connect to an ISP to access email or the
Internet. You can configure the SCS to automatically connect to an ISP and accept a
dynamically assigned IP address from the ISP.
When you configure a dial-out ISP connection using the web browser interface, a site
named outgoing is created. Once the site is properly configured, outbound packets
should cause the site outgoing to start and dial out using the modem.
1. Configure a modem to handle connections from the SCS as described earlier.
2. Click the Dial-Out link under Quick Setup.
3. Complete the following fields:
a) The Remote Username and Password for the ISP.
b) The Port that the modem is attached to (for a PC card modem, enter port 3).
c) The ISP's Telephone number.
d) If necessary, a static IP Address.
Note: Most ISPs assign a dynamic IP address. Set the IP address
field on the web page to DYNAMIC for this situation.
4. Specify a Nameserver.
6-14
To Next Page
Loading...
Need help?
General