Lantronix SCS100

Front Panel_______________________________________________________________ 4-1
Side Panel _______________________________________________________________ 4-1
DB9 Serial Connector Pinouts____________________________________________________ 4-2
PC Card Slots ________________________________________________________________ 4-2
PC Card Slot _____________________________________________________________ 4-2
Power Connectors_____________________________________________________________ 4-2
Power Jack_______________________________________________________________ 4-2
Screw Block Power ________________________________________________________ 4-3
LEDs _______________________________________________________________________ 4-3
Specifications of the SCS400 ____________________________________________________ 4-4
Power ___________________________________________________________________ 4-4
Temperature______________________________________________________________ 4-4
Humidity _________________________________________________________________ 4-4
Altitude __________________________________________________________________ 4-4
5: Installation ____________________________________________________ 5-1
Connecting the SCS ___________________________________________________________ 5-1
Assigning an IP Address ________________________________________________________ 5-2
EZWebCon Method ________________________________________________________ 5-2
DHCP Method ____________________________________________________________ 5-4
Command Line Method _____________________________________________________ 5-4
ARP and Ping Method ______________________________________________________ 5-5
BOOTP or RARP Reply Method ______________________________________________ 5-6
Configuring the SCS ___________________________________________________________ 5-7
EZWebCon Method ________________________________________________________ 5-7
Web Browser Method_______________________________________________________ 5-9
Telnet Login Method________________________________________________________ 5-9
Command Line Method _____________________________________________________ 5-9
6: Application Setup_______________________________________________ 6-1
Login Banner Pages ___________________________________________________________ 6-2
Menus ______________________________________________________________________ 6-2
Enabling Menu Mode _______________________________________________________ 6-2
Creating the Menu _________________________________________________________ 6-3
Using Menu/Connection Commands ___________________________________________ 6-4
Enabling Menu Mode for a Port _______________________________________________ 6-5
Using the Menu ___________________________________________________________ 6-6
Break Sequences _____________________________________________________________ 6-7
iv