Need help?Do you have a question about the Lanzar MNX260 and is the answer not in the manual?
Explanation of the gain control for matching amplifier sensitivity to source signal voltage.
Instructions for connecting the amplifier's ground to the vehicle chassis.
Connecting the remote turn-on terminal for amplifier activation via the head unit.
Connecting the amplifier's power input via a fuse or circuit breaker to the battery.
Diagram and notes for setting up the amplifier in 2-channel stereo mode.
Technical specifications for MNX260 and MNX460 amplifier models.
Critical safety precautions for installation and operation of the amplifier.
General| Channels | 2 |
|---|---|
| RMS Power @ 4 Ohms | 130W x 2 |
| THD | <0.05% |
| S/N Ratio | >90dB |
| Damping Factor | >200 |
| Input Impedance | 10k Ohms |
| Fuse Rating | 25A |
| Low Pass Crossover | 50Hz - 250Hz |
| Bass Boost | 0-18dB |
| Frequency Response | 10Hz - 30kHz |
| Input Sensitivity | 0.2V - 6V |
To Next Page
