Need help?Do you have a question about the Lanzar VIBE211 and is the answer not in the manual?
General| Channels | 2 |
|---|---|
| THD | <0.05% |
| Frequency Response | 15Hz - 30kHz |
| Signal-to-Noise Ratio | >95dB |
| Damping Factor | >200 |
| Input Sensitivity | 200mV-6V |
| Input Impedance | 10k Ohms |
| Fuse Rating | 20A |
| Low Pass Crossover | 50Hz - 250Hz |
| High Pass Crossover | 50Hz - 250Hz |
| Bass Boost | 0-18dB |
| RMS Power @ 4 Ohms | 100W x 2 |
| RMS Power @ 2 Ohms | 150 Watts x 2 |
| Bridged RMS Power @ 4 Ohms | 300 Watts x 1 |
Details input level, crossover, bass boost, and indicator controls for Vibe 211-261 amplifiers.
Details input level, crossover, bass boost, and indicator controls for Vibe 411-431 amplifiers.
Details input level, crossover, bass boost, mode selectors, and indicators for the Vibe 531 amplifier.
Presents technical specifications including power, impedance, frequency response, and dimensions for Vibe 211-241.
Presents technical specifications including power, impedance, frequency response, and dimensions for Vibe 251-531.
Step-by-step instructions for mounting the amplifier and connecting power, ground, and signal wires.
Essential safety guidelines covering drilling, wiring, ventilation, and power connections during installation.
Wiring diagrams for Stereo, Bridged, and Tri-Mode setups using 2-channel amplifiers.
Wiring guide for a tri-amp system utilizing multiple 2-channel amplifiers.
Wiring diagrams for Stereo and Bridged modes using 4-channel amplifiers.
Wiring diagrams for Stereo, Bridged, and Tri-Mode setups using the 5-channel Vibe 531 amplifier.
Resolving issues related to no power, protection LED activation, and overheating.
Troubleshooting hiss, engine noise, distorted sound, and high squeal noise.
To Next Page
