Lanzar Vector VCTBS8 User Manual

Mounting the subwoofer
1. Find a suitable location in the vehicle in which to mount the amplifier.
A typical location is shown below:
2. Make sure there is sufficient air circulation around the intended mounting location.
3. Mark the location for mounting hole screws by positioning the cabinet where you
wish to install
it. Make a small mark to identify the position and remove the unit.
Thoroughly clean the area you plan to attach the subwoofer, using a vacuum cleaner.
Then attach the supplied double adhesive tape, and put the subwoofer
in the place
and press down on it securely.
Troubleshooting
If you experience operation or performance problems with this product, compare your
installation with the electrical wiring diagram on the previous pages. If problems
persist, read the following troubleshooting tips which may help eliminate the problems.
PROBLEM
POSSIBLE REASON SOLUTION
• N0+12v to povver wire
• Check fuses and connections to battery
Not switching on. Power
• No povver to remote wire
• Check remote on connections to head unit
LED not 'on'
• Fuse broken
• Replace fuse with correct type and
amperage
• Fuse bIcMIn
• Replace fuse with correct type and
Not working, but status
amperage
LED 'on'
• Move unit to vented area
• Amplifier
too hot
• Turn head unit down
No sound
• Head Unit
• Check heed unit volume level
• Gain oontroI not set up
• Ensure you have set up the amplifier
gain level control
• Connections
• Check all power, remote on and ground
connections
www.lanzar.com
VCTBS8
8" Super Slim
Active Subwoofer
OWNER'S MANUAL

Lanzar Vector VCTBS8 Specifications

General

Brand	Lanzar
Model	Vector VCTBS8
Category	Subwoofer
Language	English

Summary

Mounting the Subwoofer

Troubleshooting

Power Connections

Introduction to VCTBS8

Low Level Input Wiring

High Level Input Wiring

Package Contents

Front Panel Controls and Features

Power On LED Indicator

Indicates the power status of the subwoofer. Located on the front panel.

Phase Shift Control

Helps compensate for time alignment problems in the audio system.

Input Gain Control

Adjusts subwoofer input sensitivity to prevent distortion.

Bass Boost Feature

Increases the sound level of bass frequencies.

Low Pass Filter Control

Defines the frequency range the subwoofer amplifier receives.

Remote Level Control Port

Allows independent control of subwoofer volume.

Protect LED Indicator

Indicates protection circuit activation.

Rear Panel Controls and Features

Low Level RCA Inputs

Recommended way to introduce audio signal to the subwoofer via RCA outputs.

High Level Inputs

Used when receiver lacks RCA outputs, connects speaker outputs.

Fuse Information

Specifies fuse rating and warns against incorrect replacement.

Power Terminals

Connection points for power supply to the amplifier.