11. Health & Safety
All products manufactured by LapSafe® have been thoroughly tested and certified
by an authorised and INDEPENDENT testing house before sale.
Full CE compliance, which includes the requirements of LVD and EMC directives,
is a STANDARD FEATURE of any solution manufactured by LapSafe®, as are many
more built in safety features. CE Marking can be found on the product serial
number plate, usually at the lower rear of the cabinet. CE Declaration of
Conformity Certificate is issued with each product in the User Guide Pack.
Please be advised of the following safety advice:
At no time are the rear service door of the trolley to be opened by anyone other
than an authorised person.
At no time should anyone attempt to physically li the trolley, as this could cause
injury to the persons concerned and even damage to the trolley, which will
invaldate the manufacturer’s warranty. Should the movement of the trolley
require this type of action, you are advised to seek advice from the authorised
person. In such circumstances, the matter should be referred to LapSafe® for
consultation and advice.
• Always apply the wheel brakes when the trolley is either parked or not in use.
• Disconnect the mains supply and stow the mains cable into either the cable
• management provided or on top of the unit before moving
• Always ensure that the main power lead does not present a trip hazard when
connected to the mains.
• Always ensure that the main power lead is fully extended when connected to
the mains.
• The trolley should only be moved on horizontal surfaces.
• Always ensure that the trolley NEVER impedes full and free pedestrian access
to all fire routes, fire exits and normal access routes.
• Only place the approved laptops in the trolley for recharging.
• NEVER allow unauthorised access to the service doors at the rear of the unit.
The above is not an exhaustive list. Contact LapSafe® should you have any
concerns.
To Next Page
Loading...
