Larsen & Toubro Universal Test Kit - Page 17

7.1.3 SR71 RELEASE
1) Connect the UN-PS module (AS+ and AS-) to the release.
2) Connect CL00696 (Communication cable for SR71) to COM module
(D+ and D-) from there, connect DI , RE< Ro, VCC and GND
connection to the release.
3) Connect CL00890 and CL00891 back to back and the other end of
black line of the reset kit connector flat cable id on the user’s left hand
side.
4) Short the digits input (Breaker Status) on the release to get the fault
indication after every test.
5) Connect the power chord XK13219 to the test kit.
Note : Test will start after 1 sec of pressing the TEST key.
Comm. Cable CL00696
17
SIM-KIT