English
7. Positioning the cotter pins.
Measure the distance between the middle of
each of the connectors.
Deciding the cotter pin direction.
If the measured distance is between:
• 31-43 cm (12.4-17.2 in.)
Alt. A below.
• 43-54 cm (17.2-21.6 in.) Alt. B below.
43 - 54 cm
31 - 43 cm
Alt. A Alt. B
1
3
2
A
B
8
7
- 7 -
8. Choosing the right cotter pin hole.
There are three holes in each arm. To choo-
se the hole that best suits your stroller, posi-
tion the BuggyBoard™ as close as possible to
the back of your stroller, however do make
sure that your child can stand comfortably.
Screw the cotter pin into the chosen cotter pin
hole, tighten with a coin. If the arms are too
short to fit to your stroller, use the 'Extender
Kit', see Fig 13.
To Next Page
Loading...
Need help?
General
