10
EN
3
4
Localising electrical voltages
Position the detector tip in the
area to be tested (e.g. cable,
socket. etc.).
If voltage is present, the detector
tip lights up and a signal sounds.
For safety, check all three phase conductors (L1, L2, L3) for
the presence of voltage!
!
If the acoustic signal is weak or the battery lamp is not as
bright as it should be, replace the batteries.
!
Adjustment of sensitivity
By turning the
wheel (2), the
sensitivity of the
device (5 ... 1000 VAC) can be
adjusted. This enables voltage
fields to be located at significant
distance by moving the device
over the area to be tested.
The lines under current can be determined by adjusting the sensitivity.
If voltage is present, the detector
tip lights up and a signal sounds.
2
ON / OFF
To Next Page
Loading...
Need help?
General
