LaserLiner CombiFinder Plus User Manual

15
CombiFinder Plus
Manual calibration
Pressing the CAL button (5) manually calibrates
the device. This allows measurements to be
restarted and objects to be isolated more
precisely.
Maximum sensitivity is achieved when the
device is held in the air while calibrating.
The device and the wall must maintain contact during
calibration (except for calibration in mid-air) and
throughout the entire measurement process. A hand
should remain at the device the entire time as well.
!
EN
Briefly press the Mode button (4).
METAL-SCAN: Detecting metal in all
non-metallic materials.
AC-SCAN: Locating live lines directly
under non-metallic cladding.
5
Select measurement mode
6 Measuring in METAL-SCAN mode
The tool is able to detect hidden metal in all non-metallic
materials, e.g. brick, concrete, screed, wood, plaster fibreboard,
gas concrete, ceramic and mineral building materials.
– Select METAL-SCAN (button 4).
– As soon as the display switches from CAL
to CAL OK, you can move the device.
– MOVE: Move the tool slowly across the
surface.

LaserLiner CombiFinder Plus Specifications

General

Brand	LaserLiner
Model	CombiFinder Plus
Category	Measuring Instruments
Language	English