EasyManuals Logo

LaserLiner CombiFinder Plus User Manual

LaserLiner CombiFinder Plus
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #14 background imageLoading...
Page #14 background image
14
Metal, line is nearby Metal, line found
EN
1
2
Open the battery compartment
on the housing‘s rear side and insert
a 9V
battery. Correct polarity must
be observed.
Insert battery
Switch on: Briefly press the On/Off button (4).
Switch off: Keep the On/Off button (4) pressed for 2 seconds.
AutoShutOff: The device will automatically switch itself off
about 30 seconds after the last measurement.
Operation
4
Calibration
Auto-Calibration
The automatic calibration is performed in METAL-SCAN
and AC-SCAN measurement immediately when the device
is switched on and when the measuring mode is switched.
Auto-Cal Plus
When an object has been found, the device performs another
automatic calibration in METAL-SCAN measurement. This
simplifies the process of isolating objects to be measured
and adjusting the device to different surfaces.
3
Red = Live wire warning
METAL-SCAN and AC-SCAN mode
Green = metal or live wire is nearby
Red = metal or live wire found
Symbols

Other manuals for LaserLiner CombiFinder Plus

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the LaserLiner CombiFinder Plus and is the answer not in the manual?

LaserLiner CombiFinder Plus Specifications

General IconGeneral
BrandLaserLiner
ModelCombiFinder Plus
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals