LaserLiner DampCheck Operating Instructions

10
5
EN
Tip: Moisture measuring devices that operate in accordance with
the resistance method can be used to compare measuring points –
in this case the numerical value only serves as an index value.
Take a sample measurement in a dry area of the same material,
note down the value and compare against values of the areas to
be measured. Higher values indicate more moisture. In this way it is
possible to detect moisture paths in the material irrespective of the
material or material combinations (e.g. plaster with wallpaper).
Temperature measurement
The integrated building material characteristic is adapted to
gypsum plaster. The measuring ranges for building materials
differ significantly and also vary between manufacturers. The
integrated characteristics does therefore not apply to all
possible building materials. If necessary, check values using
other measuring methods such as the Darr method.
!
To measure the ambient temperature switch the device to°C or °F.
The sensor may take longer to settle under conditions where
temperatures fluctuate considerably.
!
Notes
– Do not expose the device to mechanical stress, extreme
temperatures, moisture or significant vibration.
– The device must only be used in accordance with its intended
purpose and within the scope of the specifications. Modifications
or changes to the device are not permitted, this will otherwise
invalidate the approval and safety specifications.
– This product is a precision instrument which must be handled
with care.
– Clean with a soft, damp cloth.

LaserLiner DampCheck Specifications

General

Battery type	LR44
Battery voltage	1.5 V
Number of batteries supported	4
Storage temperature (T-T)	-10 - 50 °C
Storage relative humidity (H-H)	0 - 85 %
Built-in display	Yes
Purpose	-
Accuracy	2 %
Temperature measuring range	- °C

Weight and Dimensions

Depth	16 mm
Width	46 mm
Height	85 mm
Weight	49 g