LaserLiner DampCheck Operating Instructions

08
1
2
ON HOLD OFF
DampCheck DampCheck
1 sec 1 sec
1.
2.
3
1 sec 3 sec 1 sec 1 sec 1 sec
1x 1x 1x 1x 1x
EN
Inserting batteries
Open the battery compartment and insert
batteries according to the symbols. Be sure
to pay attention to polarity.
The device switches
off automatically
if left idle for
15 seconds.
Measurement procedure notice
Be sure neither supply lines (electric lines, water pipes, etc) nor
a metal subsurface is present at the location to be measured.
Insert the electrodes as far into the material as possible but
never use excessive or sudden impact force as this could
damage the unit. Always pull the unit out of the material with
left/right twisting motion. Perform several comparative
measurements at different locations to minimise measure-
ment error. The sharply pointed electrodes present an injury
hazard. Always put the safety cap on the unit when it is not in
use or being transported.
!
The device starts with the measuring mode last selected.
To select the mode, press and hold the Set button for
3 seconds or briefly wait until the symbol stops flashing.
!
To change measuring mode
Device on
Symbols ash
The „Battery Charge“ symbol (c)
appears on the display when the
battery charge is low.
!

LaserLiner DampCheck Specifications

General

Battery type	LR44
Battery voltage	1.5 V
Number of batteries supported	4
Storage temperature (T-T)	-10 - 50 °C
Storage relative humidity (H-H)	0 - 85 %
Built-in display	Yes
Purpose	-
Accuracy	2 %
Temperature measuring range	- °C

Weight and Dimensions

Depth	16 mm
Width	46 mm
Height	85 mm
Weight	49 g