MANUAL FOR USE AND MAINTENANCE8 LSC 001 REV. 00
HEATING PHASE AND PRESET PHASE FOR OPERATION
a) Fasten the filterholders (11) to the brewing groups (16).
b) Open (turning anti-clockwise) steam valves (5) and leave them open, then move the steam wands (8)
over the grid (10).
c) Wait for steam coming out of the steam wands (8) (about 15/20 minutes) then close the steam valves
(turning clockwise) (5).
d) Wait for the equipment to reach operating temperature, which is visualized on the manometer of the
appliance (4) (1 bar pressure).
In Seletron and Elettrik models it is possible to visualize on the display (33) the temperature (in °C) being
reached, which was set during the installation phase.
N.B. The operating temperature is the temperature of boiler during standard operation.
e) The equipment is ready for use.
COFFEE BREWING
a) Remove the filterholder (11a or 11b according if it is for 1 or 2 cups of coffee) from the brewing group
(16).
b) Fill it with ground coffee, making sure not to leave coffee powder on the upper edge of the filterholder,
and press it with the suitable coffee tamper provided.
c) Firmly attach the filterholder to the brewing group.
d) Place one or two cups below the filterholder (according if it is for 1 or 2 cups of coffee).
e) Operate on the coffee delivery button (12) of the same group and press it to start the delivery. Once you
obtain the desired coffee quantity in the cup, manually stop the delivery pressing the same button.
f) For Seletron and Ek model press any of the coffee delivery buttons with preset doses (25-26-27-28)
programmed (at the installation), otherwise the button (29) for free-flow coffee brewing (ON/OFF).
N.B. In case one has the need to stop in advance a coffee delivery started with one of the buttons
with preset doses, one simply has to press the switch-button ON/OFF (29) of the same touchpad
(except for range Super 3000 /Seletron model).
STEAMING FOR HOT DRINKS PREPARATION
a) Insert the steam wand (8) in the pitcher containing the drink to be heated up.
b) Turn the knob (5) of the corresponding steam wand (8) anti-clockwise. Set the amount of steam as
needed by turning more or less the knob (5).
c) Once the heating phase is finished, stop the steam delivery turning the knob (5) clockwise, remove the
steam wand from the pitcher and clean it immediately with a wet sponge removing all the residues of the
heated drink.
Do not turn the knob for steam delivery (5) before inserting the steam wand (8) into the pitcher in
order to prevent possible burns.
TAKING HOT WATER FOR INFUSIONS
(Range New-Rapid-Spazio-Super 3000)
a) Place the pitcher underneath the hot water spout (7).
b) Open turning anti-clockwise the hot water delivery knob (6) in order to obtain the desired water quantity.
c) Close turning clockwise the delivery knob (6) to stop the delivery.
☞
To Next Page
