MANUAL FOR USE AND MAINTENANCE
LSC 001 REV. 00 9
2
TAKING HOT WATER FOR INFUSIONS (Range S3 - EP model)
a) Place the pitcher underneath the hot water spout (7).
b) Press the hot water delivery push-button (6) to obtain the desired water quantity.
c) Press again the same push-button (6) to stop the delivery.
Do not press the hot water push-button (6) before placing the pitcher below the hot water output (7)
to prevent possible burns.
TAKING HOT WATER FOR INFUSIONS (Range S3 - EK model)
a) Place the pitcher underneath the hot water spout (7).
b) Press the water delivery push-button (6) to obtain the desired water dose.
c) The delivery stops at the end of the preset time which has been programmed at the installation.
Do not press the preset hot water push-button (6) before placing the pitcher underneath the hot
water spout (7) to prevent possible burns.
ELECTRIC CUP-WARMER
Optional on Range S3/EK-EP models
In order to have an additional heating up of the cups on the top, it is possible to use the provided electric
cup-warmer. Press the cup-warmer operating button (24) and check its operating status through the lighting
up of the led (23) on the control-panel (13). To switch it off press the same button.
New / Rapid / Spazio Range (optional)
In the appliances equipped with electric cup-warmer, to turn it on move the main switch (3), from position
1 (standard operating phase) to position 2. To switch it off, move it back to position 1.
WARNING!
It is allowed to place cups on the upper grid of the machine
(14), as long as the cups have their hollow part upwards
(pict 2).
This is in order to avoid that combustion fumes of the gas
burner, in the machines pre-arranged to work with gas
system, come into contact with the inner part of the cups,
which is supposed to contain coffee.
COFFEE COUNTER FUNCTION
(only on Range Super 3000- Seletron model)
Pressing button (38) the display visualizes “d1” followed by a number, which corresponds to the total
number of cups delivered by all brewing groups using the single short coffee selection (25). Once the reading
phase is completed, release the button (38). Repeat the same operation to visualise “d2” (single long coffee
selection), “d3” (double short coffee selection), “d4” (double long coffee selection). The sum of these 4
numbers is the total number of cups delivered using the delivery buttons with preset doses (25-26-27-28).
N.B. The cups of coffee delivered using button (29) (free-flow delivery) are not considered in the
COUNTER function. To reset this function, turn off for a while the main switch (3).
When the appliance is used under circumstances which can consistently decrease its temperature, pressing
the button “SET” (39) for about 5 seconds, the temperature of the boiler is automatically increased of 2°C:
this operating status is signalled on the display by the visualization “UP” which comes out alternating to the
standard temperature indication.
To go back to the standard operating phase, press again the button “SET” (39) for about 5 seconds.
002
☞
To Next Page
