EasyManua.ls Logo

Lastec 2961AGC - Assembly and General Inspection

Default Icon
68 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Initial Set-Up
Assembly
3
3-2 Lastec//020515 Initial Set-Up
3.1 Assembly
The Lastec Mower comes preset from the factory and ready to mow. Should adjustments
be necessary due to shipment, follow the set-up procedures listed herein.
3.2 Parking Brake
Warning
WARNING
ALWAYS set the parking brake before performing any set-up, inspection, adjust-
ments, or maintenance to your Lastec Mower!
ALWAYS release the parking brake before operating your Lastec Mower!
The parking brake is located to the left of the operator seat, just in front of the left steering
control arm. To set the parking brake, grasp the handle and pull upward, increasing the
brake tension, until the handle hits a hard stop.
To release the parking brake, push for-
ward on the handle away from the hard
stop.
LT0105

Table of Contents