Lathem TruAlign 800P - Appendix B - Calibrating the TruAlign Function

800P TruAlign Time Recorder User Guide
Page 31
CAL 1
Figure 1
Proper alignment
when the indicator
falls in the middle of
print area.
Press the  or
-
button until the display
shows ‘1’. Selecting ‘1’ activates the
TruAlign calibration mode. Press the SET
button.
The display will show ‘C
AL
1’, insert and
visually align a timecard, see Figure 1.
With the timecard fully inserted and
properly aligned, press and hold the 
button to register the alignment.
Note the value showing on the display. Shift
the card slightly left and right, the value will
increase or decrease.
When the display is at the smallest value,
release the  button, the display will show
‘CAL2’.
Remove the timecard.
C A L 1
15: 1
F
unction
#
TruAlign
Calibration