Lathem TruAlign 800P - Wall Mount; Mounting to a Wall

800P TruAlign Time Recorder User Guide
Page 26
Wall Mount
Select a site to install the 800P time recorder that will be
convenient to employees clocking In and Out. The 800P time
recorder can be mounted directly to a wall. When deciding
where the time recorder will be installed, keep in mind that
115VAC power outlet should be within 6 feet of the mounting
location.
Mounting to a Wall
Note: If you are installing the time recorder on a wall with
drywall, it is recommended to use a “Molly Bolt” or Toggle
Bolt” type of wall anchor.
Step 2
Remove the Philips head screw
holding the back-plate on the
time recorder. Be sure to retain
the Philips head screw for
later.
Step 1
Using the wall-mount bracket as a
guide, mark the location on the wall
of where the screws will be installed.
Run the AC wall adapter cord through
hole in the wall-mount bracket and
then install the wall-mount bracket to
the wall using the supplied wall-
mount screws. Note: The time
recorder should be mounted for best
visibility, about 48 inches from the
floor.
Run wall adapter
cord from
underneath through
the center hole in
wall-mount bracket.
48
inches