LaTrax Alias 6608 - MODEL ORIENTATION; FLYING YOUR MODEL

4
ENGLISH
FLYING YOUR MODEL
t5IFNPEFMXJMMSFBDURVJDLMZUPZPVSDPNNBOET"UýSTUNPWFUIFDPOUSPMT4-08-:
and make small, gentle control movements to avoid loss of control. If you ever feel you
don’t have complete control of the helicopter, maintain altitude with the throttle stick and
release the opposite stick to return to level ight (Normal and Expert 1 (EXP1) Mode).
t'MZGFFUBCPWFUIFHSPVOEUPBWPJEHSPVOEUVSCVMFODFGPSBNPSFTUBCMFBOE
controllable ight.
1. Find a suitable ying area. Alias is approved for both indoor and outdoor ight. The
recommended minimum area for indoor ight is 10 x 10 feet, with a ceiling height of 8
feet or more. Be aware that the spinning rotor blades may damage furniture and wall
coverings. When ying outdoors, choose a wide open area away from crowds, buildings,
power lines, or other hazards.
2. Switch the transmitter on. The transmitter will emit a tone. Observe the battery level
indicator on the LCD. Replace the batteries when only one segment is displayed. Do not
y the model with low transmitter batteries or loss of control may result.
Alias does not have a power switch.
The model is ON when the battery is connected. To power the model off,
disconnect the battery.
WARNING: To prevent permanent damage to your battery pack,
ALWAYS disconnect the battery whenever the helicopter is not in use.
3. Power the model.
t$POOFDUUIFCBUUFSZUPUIFNPEFM5IFNPEFMJTOPXQPXFSFEPO
t8IFOUIFHSFFO-&%POUIFUSBOTNJUUFSBOEUIFCMVF-&%POUIFIFMJDPQUFSBSFCPUI
solid (not blinking), and the “RX” battery level indicator appears on the LCD screen,
linking is complete.
4. Place the model on a level surface in the center of your ying area,
with the front of the model facing away from you (nose out).
5. Arm your model for ight. Move the throttle stick to the full
down position (throttle off). The helicopter will not arm unless the
throttle stick is in the down position. Push in and click the throttle
stick to arm your model for ight. The transmitter will emit a tone
indicating that the helicopter is armed and ready to y.
Note: When the throttle stick is left idle for 5 seconds or the
helicopter detects an impact, the helicopter will automatically disarm.
MODEL ORIENTATION
REAR
Black Rotor Blades
White Lights
FRONT
Color Rotor Blades
Color Lights
KC1829-R01-Alias-Owners-Manual-130916.indd 4 9/16/13 5:24 PM