LaTrax Alias 6608 - FLYING TIPS

5
ENGLISH
6. Fly the helicopter. Gently push the throttle stick forward to
increase the RPM of the main rotors until the model begins to lift
off. Reduce throttle to maintain a hover when the model is at least
2–3 feet off the ground. This height will keep the model away from
ground turbulence for more stable ight.
t1SBDUJDFNBJOUBJOJOHUIFIPWFSQPTJUJPO.JOPSDPOUSPMJOQVUT
are required to keep the model hovering in one spot and at
one altitude.
t1SBDUJDFJODSFBTJOHBOESFEVDJOHBMUJUVEF5PMBOETMPXMZ
and smoothly pull the throttle stick back until the helicopter
touches down.
t1SBDUJDFþZJOHGPSXBSEBOECBDLXBSE0QFSBUFUIFFMFWBUPS
and aileron controls separately to familiarize yourself with the
helicopter’s response.
t1SBDUJDFSPUBUJOHBOETUPQQJOHUIFIFMJDPQUFSQSFDJTFMZ
Operate the rudder control while hovering.
t$PNCJOFDPOUSPMDPNNBOET8IFOZPVBSFDPNGPSUBCMFPQFSBUJOHUIFDPOUSPMT
independently, you can combine controls to make very precise maneuvers.
The transmitter and receiver are equipped with an automatic fail-safe system. In
the event of signal loss or interference, the ight control will be shut down and the
helicopter will execute a controlled landing. If failsafe activates, determine the reason for
signal loss and resolve the problem before operating the helicopter again.
If one or more of the rotor blades are obstructed, the helicopter will disarm itself and
all of the LED lights on the helicopter will ash. Move the helicopter to a clear area,
arm the helicopter again, and continue ying. If the helicopter will not y correctly or the
LED lights start ashing again, unplug the battery and inspect the helicopter for damage.
FLYING TIPS
Controls are reversed as the model ies toward you.
t8IFOZPVSNPEFMJTþZJOHBXBZGSPNZPVUIFIFMJDPQUFSSFBDUTUPEJSFDUJPODIBOHFTKVTU
as you command. If you command the model to move right, it will move to your right as
you commanded.
t8IFOUIFIFMJDPQUFSJTDPNJOHUPXBSEZPVBOEZPV
command the model to move right, the model will
move to your left. Always remember that the model
ies forward, reverse, right, and left relative to the
position of itself, not relative to your position.
t6OUJMZPVCFDPNFVTFEUPSFWFSTJOHZPVSDPOUSPM
inputs as the model changes direction, allow yourself
extra ying room to accommodate pilot error.
t5PIFMQXJUIEJSFDUJPOBMDPOUSPMJUNBZIFMQUPJNBHJOF
yourself sitting in the cockpit of the helicopter.
Indoor Flying Tips:
t5IFIFMJDPQUFSJTTFOTJUJWFUPBJSDVSSFOUTJOUIFSPPNBOEUVSCVMFODFUIBUJTDSFBUFEXIFO
the helicopter is near the ground, walls, and ceilings. Pilot correction will be required.
Stay 2-3 feet away from ceilings and walls.
t/PUFUIBUBJSWFOUTBJSDPOEJUJPOFSTSPPNGBOTBOEPUIFSEFWJDFTUIBUDJSDVMBUFBJSNBZ
affect your model and cause unpredictable movements. Avoid obstacles such as ceiling
fans and re sprinkler heads.
KC1829-R01-Alias-Owners-Manual-130916.indd 5 9/16/13 5:24 PM