EasyManua.ls Logo

Latronics PV Edge Grid Connect - Operation and Troubleshooting; RADIO FREQUENCY INTERFERENCE; AC WIRING

Latronics PV Edge Grid Connect
12 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
ACWIRING
Bothmodelsrequireanexternal10A circuitbreakerforprotectionof
inverter’s ACinput.Usuallymountedinmainswitchboard. Theactiveand
neutralofthe ACoutputareelectricallyisolatedfromtheDCinputsandearth
connections.
LatronicsInvertershavethe ACoutput(activeandneutral)floatingwith
respecttotheDCandEarth. Thisconfigurationprovidesthehighestsafety
andmostflexibilityforinstallationwiring. Theearth isconnectedinternally
totheInvertercaseandissuitablefor wiring.
Theunitissuppliedwithbothmaleandfemale20AmpWielandGesis
lockable ACconnectorsthat
Toinstallconnectorsreadthefollowingprocedure.
1. MakesureInverterisswitchedOFFbeforeworkingonmainswiring. Turn
external ACCircuitBreakerswitchintoOFFpositionand
makesureitcannotbeswitchedbackon.
2. Testthewiringwithavoltmetertomakesurenovoltageispresent.
3. Peelback30mmofcablejacketandcut ActiveandNeutralcables
5mmshorterthanEarth.
4. Strip5mmoffallthreecables.
5. TaketheWielandGesisconnector,disassembleintothreemainsections
andinsertstrippedwirethroughasshownbelow.
E
canbedisconnectedunderfullloadand
complieswith AS4777standardsforanisolatorattheinverter.
MEN
30mm
Earth
PressureRing
MainBody
Socket
Round2.5sqmmTwin&EarthCable
RADIOFREQUENCY INTERFERENCE
RadioFrequencyInterference(RFI)isaphenomenonthatexistsinmodern
societyandisaprobleminmanyareasofelectronics.ForInverterusers,
RFInormallypresentsitselfintheformofstaticand/orinterferencewhen
listeningtoan AMradioandinunusualcasesmayinterferewith TVreception.
OvertheyearsLatronicshascontinuedtoinvestsignificanttimeandeffortin
thereductionofRFIrelatedemissionsfromtheentireproductrange,sothat
theycomplywiththeappropriateInternationaland/or AustralianStandards.
Evenwiththiscompliance,therearesituationswhereRFImaystillbeacause
forconcern,andcandiffergreatlyfrominstallationtoinstallation. Accordingly,
thefollowingisalistofrecommendationsmadetoassistintheoverall
reductionofRFI.
1. AvoidrunningDCand ACcablesinthe
sameconduitsand/orcabletrenches.Itisstronglyrecommendedthat
DCand ACwiringbeseparatedbythegreatestdistancepossible.In
extreme cases,theuseofshieldedconduitmaybenecessary.
2. .DCcablescanactasanaerial,
thereforeallsuchcablesshouldbekeptasshortasispracticable.For
bestperformanceminimizeDCcablelengthtoInverterandBatteriesand
ifpossibleavoidtheuseofauxiliaryDCloads.
3. .Forhouseholdinstallations,itisrecommendedthata
“good”EarthStakeislocatedasnearbytheInverterasispossible.
4. Thesetypesofradioequipmentinherentlysuffer
fromallformsofRFI,especiallywhenthereceivedsignallevelisweak.
Insuchcasesreceptioncansometimesbeimprovedbyrelocationofthe
radioitself,alternativelytheuseofanappropriateexternalantenna and
co-axialcable maybenecessary.Externalantennasshouldbelocated
inamannerthatensuresmaximumsignalstrengthwhilstaffordingthe
greatestpossibledistanceawayfromtheInverterandBatteries.
5. TVsignalsaretransmittedasFMwaveforms. Thistypeof
signalfundamentallyreducestheeffectsofRFI,thereforetheuseofa
goodantennaandfeedercableisnormallysufficienttoensurequality
reception.LocatingthetelevisionasfaraspossiblefromtheInvertermay
alsoimprovepictureclarity.
SeparateDCand ACwiring.
MinimizelengthofDCcabling
240VacEarth
AMandHFRadios.
Televisions.
16
5

Related product manuals