Lattice Semiconductor MachXO2 Quick Start

MachXO2 Dual Sensor
Interface Board
Connect the DSIB, HDR-60 and NanoVesta Boards
The DSIB plugs into an HDR-60 Base board, which is required and is available separately. In
addition, at least one 9MT024 NanoVesta board is required. Two 9MT024 NanoVesta boards
are needed for dual sensor or 3D video support. Optionally, the AR0331 NanoVesta (Aptina) or
MN34041 NanoVesta (Panasonic) boards can be plugged in to the DSIB, but dual implementa-
tion of those boards is currently not supported.
This document provides a brief introduction and instructions to install and demonstrate the
MachXO2™ Dual Sensor Interface Board (DSIB) on Windows 7/Vista/XP/2000. Further infor-
mation, including the MachXO2 Dual Sensor Interface Board User’s Guide (EB69), is available
on the Lattice website at www.latticesemi.com/dualsensorbridge.
Check Kit Contents
The DSIB box includes the following items:
• MachXO2DualSensorInterfaceBoard
• QuickSTARTGuide
Storage and Handling Tips:
Static electricity can shorten the lifespan of electronic components. Please observe these tips to
prevent damage that could occur from electro-static discharge:
• Useanti-staticprecautionssuchasoperatingonananti-staticmatandwearingananti-static
wristband.
• StoretheMachXO2DualSensorInterfaceBoardintheanti-staticbagprovided.
• TouchthemetalUSBhousingtoequalizevoltagepotentialbetweenyouandtheboard.
This procedure is continued on the next page.
MachXO2 PLDISSI SDRAM
NanoVesta
Sensor #1
Connectors
TI IPNC
Connector
FTDI
USBLEDs
NanoVesta
Sensor #2
Connectors

Lattice Semiconductor MachXO2 Specifications

General

Brand	Lattice Semiconductor
Model	MachXO2
Category	Controller
Language	English