© Elektronik-Systeme LAUER GmbH & Co. KG • Kelterstr. 59 • 72669 Unterensingen • Tel. 07022/9660-0 • Fax 07022/9660-103
9
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
1 Preparation
1.1 List of supplied equipment
The transport cardboard box contains the following parts and materials:
CD with operating system.
Driver software CD for all pre-installed components like mother board,
touch, key board etc. Further information will be found in chapter
„installation“.
User manual
Notice! Separate documentation of third party components is included on
the enclosed CD. This manual only describes specific information about
LAUER products – not about third party components.
The LAUER appliance pass is supplied with every appliance. It contains
important information for the user. Ready to hand are important address
data, serial number, then there are the components and type designation
corresponding with the company internal appliance designation.
Also shown are all components contained in the system – therefore the
CPU and hard disk type or the operation system are easily identifiable for
the user.
Your advantages:
• all important contact data for a fast and uncomplicated handling for
desired improvements, general queries or for service purposes.
• complete configuration of your system including serial number.
Fixing kit
8 Stainless steel screws with washers/nuts and O-ring seals are contained
in the parcel of each EPC PM 1700, 1900, 2100 Nautic, MT 217, 219 and
MT 221 Nautic.
Documents
To Next Page
Loading...
Need help?
General
