LAUNCH TECH X-431 V - Wi-Fi Network Setup; Connecting to Wi-Fi; Disconnecting from Wi-Fi

LAUNCH X-431 V User Manual — Wi-Fi Setup
9
3 Wi-Fi Setting
Note: If you don’t need to use Wi-Fi for a while, you can turn it off to conserve
battery life.
X-431 V has built-in Wi-Fi that can be used to get online. Once you’re online,
you can register your X-431 V, browse the Internet, get apps, send email and
check for software updates.
3.1 Connect to a Wi-Fi network
1. On the home screen, tap Settings > WLAN.
2. Slide the Wi-Fi switch to ON, X-431 V will start searching for available
wireless networks.
3. Select a wireless network,
y
If the chosen network is open, X-431 V will connect automatically;
y
If the selected network is encrypted, a network password will need to be
entered.
4. When “Connected” appears, tap
to exit and return to the home screen.
Note: When Wi-Fi is not required, this should be disabled to conserve battery
power.
Once it is connected successfully, tap the Wi-Fi network from the list to view its
name, link speed, security type, IP address etc.
When this tool is in range, it will connect to the previously linked network
automatically.
3.2 Disconnect from a Wi-Fi network
1. On home screen, tap Settings > WLAN.
2. Tap the network with a
Connected
status, then tap “Disconnect”.