LAUNCH X431 GDS Sensorbox Manual
11
[Voltage] Display current square wave signal voltage value
[Duty cycle（%）] Display current square wave signal duty cycle
After finished setting, click [Start] to perform Constant frequency simulation.
3.2.3 Predefinition waveform simulation
X-431 GDS provides the common sensor waveforms which have been
defined to facilitate so that users to simulate sensor signals as long as calling
out the predefined waveform (after "sensor type" and "wave type" being
selected, the simulation waveform will be displayed on the left of the
coordinates. If click "Start", you can simulate the output of corresponding
sensor waveform, and there is no need to set the parameters of simulation
waveform.
On Figure 3-1, select "Predefined waveform simulation", then click [Enter] to
enter the interface as shown below Figure3-4:
To Next Page
Loading...