LAUNCH X431 GDS Sensorbox Manual
15
which needs to be simulated in left drawing zone, and setting some
parameters such as waveform high level, waveform lower level, and period
of waveform, then click [Start], X431 GDS can output a waveform which
users want to
Warning:
It is ok to draw a periodic integrated waveform (when it is outputted,
the system will consider the waveform in the draw section as a periodic
one). Users should be drawing a wave in drawing zone so that
sampling more point for reduce tolerance. Users don’t need to consider
the crest &bottom level and period in the draw section. Only need to set
the crest & bottom level and period in the right parameter setting
section.
On Figure 3-1, select "Hand-drawn waveform simulation", and then click
[Enter] to enter the interface, as shown on Figure 3-8
To Next Page
Loading...