LAUNCH Tyre Changer(TWC Series)
iii
² Caution should be taken
when separating the tyre
bead from rim. The bead
breaker shoe will move
rapidly and forcefully when
the pedal is depressed.
Keep hands and other parts
of body away from moving
parts.
² If the clamping cylinder is
working when bead
breaking, to avoid
squeezing hands,
remember to keep hands
away from the sidewalk
tyre.
² High voltage power!
Danger!
² This is where the
compressed air gun is
connected with the air pipe.
Connect the compressed air
gun with the air connector.
² The pressure of the
compressed air should not
exceed 10 bar.
Description of Safety Signs
² To prevent accidents from
occurring, make sure to
keep hands and other parts
of the body away from
moving parts when
fastening the mounting
head or when the turntable
is running.
² Be careful when connecting
and disconnecting air
source. Exhaust the air in
the cylinder completely
when maintaining the air
pipes to prevent accidents
from occurring.
² Don’t keep hands or other
body parts between the
clamping jaw and clamping
rim.
² Pay attention to the safety
regulations in the swinging
area of the tilting post to
avoid accidents from
happening.
² Before inflating check if the
clamping rim and the tyre
match each other, and if
they are in good condition.
Any negligence may result
in fatal explosion. Similar
accident may occur if the
inflating air exceeds the
allowed tire pressure.
To Next Page
Need help?
General
