10
Before calling customer service check the following points.
Problems and solutions
FER
Problem
• The soleplate is dripping.
• The iron does not heat up.
• The iron is too hot.
Probable cause
• The iron is not ready.
• The thermostat is not well
adjusted.
• The boiler has not been
rinsed recently.
• The boiler has been rinsed
with a product other than
water.
• Disconnected at the wall.
• Switches are off.
• The thermostat is not well
adjusted.
What to do
• Wait for the iron ready indicator
light to come on.
• Adjust the thermostat following
indications see p.4
• Rinse the boiler until the water no
longer contains any residues see p.7.
• Call customer service.
• Plug in at the wall.
• Switch them on.
• Adjust the thermostat following
indications see p.4.
We are glad to be of assistance. Our address is indicated on the last page.
English
VENTILATOR
Problem
• The vacuum produces no sound
• The tip of the table becomes
wet in the storage position.
Probable cause
• The ventilator cable is
unplugged.
• Normal condensation in the
cap.
What to do
• Plug it in.
• Leave the unit open until the
water has evaporated.
• Use less steam. Pay attention to
the instructions for use with
respect to vacuuming and
blowing see p.8.
Problem
• Emits a humming sound when
steam is ejected from the iron.
• Cracking sounds when the
boiler is lit.
• The green light comes on
and goes off during ironing.
• The iron is no longer pro-
ducing steam. Pressure has
fallen.
BOILER
Probable cause
• The boiler is vibrating.
• The boiler is being heated
without being refilled
• Water is warming up.
• The boiler is empty.
• The switches are off.
• The wall socket is disconnected.
What to do
• This noise is normal for a new
appliance, it will disappear in the
course of use.
• Fill the boiler with water. See p.6.
• This is normal.
• Fill the boiler with water. See p.6.
• Switch both switches on.
• Connect to the wall socket.
To Next Page
Loading...
