IMPORTANT SAFEGUARDS
When using your flatiron, basic safety precautions should always be followed, including the
following:
READ ALL INSTRUCTIONS BEFORE USING
1. Use iron only for its intended use. 2. To protect against a risk of electric shock, do not
immerse the iron in water or other liquids. 3. The iron should always be turned to off before
plugging or unplugging from outlet. Never yank cord to disconnect from outlet; instead, grasp
plug and pull to disconnect. 4. Do not allow cord to touch hot surfaces. Let iron cool completely
before putting away. Loop cord loosely around iron when storing. 5. Always disconnect iron
from electrical outlet when filling with water or emptying and when not in use. 6. Do not
operate iron with a damaged cord or if the iron has been dropped or damaged. To avoid the risk
of electric shock, do not disassemble the iron, take it to a qualified service person for
examination and repair. Incorrect reassembly can cause a risk of electric shock when the iron
is used. 7. Close supervision is necessary for any appliance being used by or near children. Do
not leave iron unattended while connected or on an ironing board. 8. Burns can occur from
touching hot metal parts, hot water, or steam. Use caution when you turn a steam iron upside
down. 9. If you notice any malfunction, disconnect the power supply and don’t attempt to repair
the appliance, but contact the Customer Service Center 10. WARNING! Risk of burns! After
unplugging the iron, allow it to cool for at least 2 hours before unscrewing the DRAIN cap for
rinsing.
SPECIAL INSTRUCTIONS
1. To avoid a circuit overload, do not operate another high wattage appliance on the same
circuit. 2. If an extension cord is absolutely necessary, a 15-ampere cord should be used. Cords
rated for less amperage may overheat. Care should be taken to arrange the cord so that it
cannot be pulled or tripped over.
SAVE THESE INSTRUCTIONS
Operating
Instructions
English
10/2002 (USA) Art. N° 504.0600.723
Español
Français
To Next Page
Need help?
General
