8
Cleaning the iron
Please refer to the instructions below for rinsing.
1. Disconnect the power supply.
2. Allow the appliance to cool for at least 2 hours.
3. Fix the board in the highest position.
4. Place the drain receptacle under the boiler.
5. Unscrew the drain cap.
6. Unscrew the filling cap.
7. Pass the contents of a bottle of tap water through the boiler to
remove any scale.
8. Repeat this operation until the water coming out of the boiler is free
of residues.
9. Screw the drain cap back on.
10. Fill up with water.
11. Screw the filling cap back on.
N.B.: If no water comes out of the drain opening this should be unblocked
with a pointed instrument.
Rinsing the boiler - cold appliance!
Maintenance
Risk of burns! Make sure the appliance is cold before rinsing. After unplugging,
allow the appliance to cool for at least 2 hours before rinsing.
Rinse Table
Calcium content Number of hours use between two rinses
Weak or zero 20 hours
Average 15 hours
High 10 hours (following indications p.3)
Use our Poli-Fer cleaning mat which you can obtain from your supplier making
sure you follow the written instructions. Clean the soleplate more often if you
use starch when ironing (even if the starch deposit is not visible).
• DO NOT use a de-scaler or other chemical product as they may damage the
boiler and the iron.
• DO NOT immerse the iron in liquid of any sort.
• DO NOT hold the iron under running water from the tap.
• DO NOT open the Drain Cap Except as instructed below.
To prolong the efficiency of the boiler and avoid calcium deposits, you must rinse the boiler regularly.
WARNING
WARNING
English
Risk of splashes.
WARNING
To Next Page
Loading...
