LauraStar SMART - System Start-up and Interface; Filling the Water Reservoir; Powering On the Appliance

LAURASTAR
ON/OFF
SenSteam
Pulse
Fan speed
Water
MAX
10 min.
3-5 min.
A
B
C
Start up
CAUTION : ALWAYS fill the water reservoir (11) completely
before turning on your Laurastar. Operating the appliance
without water could damage the appliance.
PLEASE NOTE : Operating the appliance without water will
void any limited warranties provided with your appliance.
Installation of the anti-scale cartridge and filling
• Check that the power plug is disconnected from the mains socket.
• Set the ironing board to its highest position.
• Take the water reservoir (11) out. Take off the water reservoir lids.
Install the anti-scale filter (13).
A
• Fill the reservoir with tap water. The filtered water has to reach the
MAX level.
B
• Close the water reservoir with the lids and put the reservoir back on
the steam generator (15).
User interface
• ON/OFF = the green indicator light flashes until the appliance is ready
to be used.
• = Option Laurastar SenSteam. If your appliance is equipped with
the Laurastar SenSteam option (17), the white indicator light signals
that the function is on.
• = Option Pulsed Steam. If your appliance is equipped with the
Pulsed Steam option (18), the white indicator light signals that the
function is ON. Fan speed button (19) = choice of four speeds. The
white indicator light signals the intensity chosen.
• Empty water light (20) = the red drop shaped indicator light signals
that there is no more water in the reservoir (11).
Switching on your appliance
• Insert the power plug (23) in the socket. If your model is equipped
with the automatic rewinder, first pull the electric cable untill the
end-of-cable mark is visible at the rewinder opening.
• Press the main ON/OFF button(16), the green indicator light will flash
for 3-5 minutes.
C
• When the green indicator light stops flashing and stays on, the appli-
ance is ready. You can start ironing.
• NOTE : For your comfort and safety, your Laurastar system
will switch off after 10 minutes of non-use.
LauraStar Auto Steam Picto 01/09/16
LauraStar Auto Picto 01/09/16
- 8 -
EN