61
EN
If you wish more foam in the beverage, you can increase
the amount of the same by pressing the FOAM control
button .
The machine will emit an acoustic signal when the button
is pressed.
If you wish to go back to the normal foam amount, press
the FOAM control button again .
The machine will emit an acoustic signal when the button
is pressed.
The foam amount cannot be changed when the
beverage is being supplied.
PREPARING THE MILK-BASED BEVERAGES
Press the CAPPUCCINO (80 cc) button to start
the machine. After a few seconds the machine will start
to warm and froth the milk. When ready, the machine
delivers the measure of coffee in the jug and stops au-
tomatically.
Do not use the milk frothing jug to conserve
the beverages. Always clean the jug thoroughly
after each use.
The supply button will light up to a blinking white light
when the product is being supplied. You can stop supply-
ing by pressing the supply button again.
Do not make more than 5 consecutive beverages.
The machine will be ready to use again after about 10
minutes.
To Next Page
