LAVAZZA DESEA - Page 70

70
ITEN
MAINTENANCE AND CLEANING
During the descaling cycle, the machine will auto-
matically perform intermittent supply cycles, to
allow the container to be emptied.
The descaling cycle can be temporarily interrupted by
pressing either the FREE DOSE button , On/Stand-
by button . To start the cycle again, press the FREE
DOSE button .
The cycle will be temporarily interrupted when the flu-
id runs out in the machine tank.
Empty the container used to collect the solution.
On/Stand-by , FREE DOSE button and “No
water” warning lamp will be ON to a steady light.
Descaling warning lamp will be ON and blinking.
Remove the water tank, rinse and wash it accurately.
Fill it with drinking fresh non-carbonated water up to
the MAX. level.
In case of power supply interruption, the machine will,
upon the first power-on, request the rinsing cycle.
Fit the tank with water.
Place a container with a capacity of at least 0.5 litres
under the supply device.
Press the FREE DOSE button to start he rinsing
cycle .
To end the rinsing cycle, a minimum amount of water will
have to be supplied. In case of lack of water, the cycle will
be temporarily interrupted, the machine will emit a pro-
longed acoustic signal and the “No water” warning lamp
will come on to a steady light. Top the tank up.
Then the supply has been completed, clean the ma-
chine by means of a moist, soft cloth.
After cleaning the machine, the descaling process will
be over.
The machine will be ready for use.