24
RE-ASSEMBLING THE CUP STAND
In order to prevent permanent damage to the cup stand when
dropped, it has been designed to come apart and can be re-assembled
by following the below steps:
Align all three
corresponding teeth
Engage each tooth at a time
and squeeze the inner ring to
engage the third tooth
Press and ring
turns freely
(Fig1)
RESETTING THE CUP STAND TO ITS LOWEST POSITION
AFTER CLEANING
1
2 3
(Fig2)
Hold the outer part of the cup stand and turn it upside down.
The inner part should then slide inside on its own.
Turn the cup stand right side up again to keep the stand in its
lowest state.
After disassembly of the drip tray, the cup stand may occasionally
become extended. Do not force it at into its lower position, as
doing so may damage the part. To return the cup stand to its lowest
position, simply follow the steps below:
2
3
1
To Next Page
Loading...
