LAVAZZA LB 4200 User Manual

Fast guide. Instructions for the user -EN-
rev 03 - 03/2016 - cod. WY02000580
LB4200 coee - coee
Preparation of the water tank
• Turnthekeyandopenthetankdoor(1);
• extractthetankfromitshousing;
• carefullywashthetankwithlukewarmwater;
• installthenewlter(A);
• llthetankwithpotablewater;
• properlyinsertthetankintotheseatandclose
thedoorwiththekey.
Forsubsequentfillingwithwater,itisnot
necessarytoremovethetankfromitsseat;
Coee delivery
• Putthecoffeecupunderthedispensing
spout;
• lifttheleveroftheunit(2)andinserta
LAVAZZABLUEpod;
• lowertheleveroftheunit;
• pressthedesireddosebutton(e.g.
):
andwaitforcoeetobedelivered(theLED
comeson);
• tostopthedeliveryofcoffeeinadvance,
pressthedeliverybuttonagain(e.g.
)
or ;
Incaseofuseofsmallcups,thecupraising
grilleisavailable(14).
Dispensing hot water
• Placethejugunderthehotwaternozzle(7);
• turnthetapknob(4)counterclockwise:the
hotwatercomingoutwillbeproportionalto
theopeningofthetap;
• tointerruptthesteamdispensingturnthe
knobcounter-clockwise(4).
Steam dispensing
• Immergethesteamnozzle(8)intheliquid
tobeheated;
• turnthetapknob(3)counterclockwise:the
hotsteamcomingoutwillbeproportionalto
theopeningofthetap;
• tointerruptthesteamdispensingturnthe
knobcounter-clockwise(3).
Foroptimalfoaming,itisrecommendedto
observethefollowingsimplerules:
• Heatonlytheamountofmilkthatyouintend
touse(DONOTusealreadyheatedmilk
severaltimes);
• themilktobefoamedmusthaveastarting
temperatureof4°C.
Start-up
• Connectthemachinetothepowersupplyby
puggingthepowercord;
• TurntheswitchON(9);
• theautomaticllingofwaterintheboilerand
thedispenserunitheatingareactivatedwhen
themachineisswitchedon;
• whenthefillingofwaterintheboilerhas
finishedtheservicesboilerheatingphase
starts,indicatedbythesequentialashingof
theLEDsofthekeys;
• waitforthecoffeemachinetowarmup
completely,indicatedbythelightingofthe
LEDs(5).
• positionalargepitcherunderthespout;
• liftandlowertheleveroftheunit;
• afterdispensing5times,therstwashingstagewillend,theLEDofbutton(6)
keepsashing;
• checkthattheunitleverisclosed,
thenpressbutton(6)againwithin
10secondstostarttheprocess,the
correspondingLEDashes;
• pressbutton(6)again;
• waitfortheperformingoftherinse
indicatedbytheashingofbutton
(6)LED.
• attheendoftheprocedure,theboilertemperaturewillberestored(seeHeating
upthemachine).
Washing
Perform unit washing.
The led of button (6) of the unit that
requires the wash ashes quickly.
• pressandholdbutton(6)for5
seconds,thecorrespondingLED
goeso;
WASH PROGRAM
WASH PROGRAM
WASH PROGRAM
WASH PROGRAM
WASH PROGRAM
WASH PROGRAM
Heating up the machine
Flashing from LH to RH
Machine ready: all the LEDs are on.
WASH WASHSTOP
PROGRAM
STOP
PROGRAM
WASH WASHSTOP
PROGRAM
STOP
PROGRAM
A
1 2 2
4
7
5
3
8
9
1014
1 Long coee 2 Long coees 1 Medium coee 1 Espresso 2 Espressos 2 Medium coees Continuous coee

LAVAZZA LB 4200 Specifications

General

Type	Capsule Coffee Machine
Model	LB 4200
Brand	Lavazza
Capsule System	Lavazza BLUE
Compatible Pods	Lavazza BLUE capsules
Frequency	50-60 Hz
Color	Black
Voltage	220-240 volts

Summary

Preparation and Startup

Prepare Water Tank

Instructions for removing, washing, and refilling the water tank with a new filter.

Machine Startup Sequence

Steps to connect power, turn on the machine, and wait for heating completion indicated by LEDs.

Coffee and Hot Water Dispensing

Coffee Delivery Process

Steps for inserting a pod, dispensing coffee, and stopping delivery.

Dispense Hot Water

Guide for dispensing hot water using the hot water nozzle.

Steam Dispensing

Instructions for steaming liquids, including tips for optimal foaming.

Machine Status and Maintenance

Heating Up Status

Indicates machine heating status via LED flashing and final ready state.

Perform Unit Washing

Steps to initiate and monitor the unit washing process using button (6) and LED indicators.

Descaling and Warnings

Thermoblock Descaling Procedure

Detailed steps to perform the descaling cycle for the thermoblock.

Control Panel LED Warnings

Interpretation of various LED patterns indicating machine status and errors.

Boiler Level Indicator

Explanation of the boiler level LED (10) states: correct, filling, or timed out.