Why are there grounds in my cup from my LAVAZZA Coffee Maker?
If you find grounds in your cup from your LAVAZZA Coffee Maker, the capsule-holder might be dirty; clean it. If the lower perforator holes are worn, replace the lower perforator. A worn internal gasket can also cause this; reduce the boiler temperature. Finally, if the temperature of the dispensed water is too high, replace the reducer with one of a smaller diameter.
Why is my LAVAZZA LB 2800 leaking water?
If your LAVAZZA Coffee Maker is leaking water, first check the sewer drain to ensure the drain tray is discharging correctly. Next, inspect the drain pipe for breaks, detachments, or clogs, and restore its connection to the drain tray. Finally, check the hydraulic circuit for water leaks and eliminate them.
What to do if my LAVAZZA LB 2800 does not dispense?
If your LAVAZZA Coffee Maker isn't dispensing coffee, first ensure there's water in the mains. If water is available, the issue might stem from a defective solenoid valve in the brewing unit, requiring replacement. Alternatively, the pump could be jammed, necessitating its replacement. A burnt-out fuse in the control unit could also be the culprit; replace the solenoid valve protection fuse (1A). Other potential causes include a clogged injector (clean or replace it), a clogged or dirty brewing unit solenoid valve (clean or replace it), or a jammed flowmeter (check/replace it).
Why there is no electrical power on my LAVAZZA LB 2800?
If your LAVAZZA Coffee Maker has no electrical power, ensure the on/off switch is in the “I” position. If it is already in that position, the switch itself might be damaged and need replacement. Also, verify that the network switch is in the ON position. Finally, check for any defects in the electrical network connection.
Why is the coffee too hot from my LAVAZZA LB 2800?
If the coffee from your LAVAZZA Coffee Maker is too hot, the boiler temperature may be too high; try reducing it. Another possibility is that the flow reducer of the brewing unit isn't suitable; replace it with one of a smaller diameter.
Why is the coffee dispensed too slowly from my LAVAZZA Coffee Maker?
If the coffee dispensed by your LAVAZZA Coffee Maker is too slow, the injector of the brewing unit might be clogged; try replacing it. Alternatively, the brewing unit itself could be clogged; check and clean it. Also, inspect the capsule-holder for dirt and clean it. If the lower perforators are dirty, clean them and replace them if necessary.
Why is the pump noisy in my LAVAZZA Coffee Maker?
If the pump in your LAVAZZA Coffee Maker is noisy, the pump and the motor might be misaligned; install the pump-motor joint. The gasket or the o-ring of the pressure adjusting screw or the filter could be defective; replace them, taking care not to change the calibration of the pump. Check if the joint, the coupling screw, or the V-shaped clamp are loose; align and tighten the components which are loose. The inlet may be clogged, even partially; clean the pump filter. Finally, the hex nut of the pressure adjusting screw or the filter might be loose; tighten the hex connection of the pressure adjusting screw and the filter.
Why is the pump leaking water in my LAVAZZA LB 2800?
If the pump in your LAVAZZA Coffee Maker leaks water, it could be due to a poor mechanical seal of the shaft or the O-Ring; check the pump and take any corrective actions. Loose inlet and outlet connections can also cause leaks; tighten the connectors. Additionally, check if the hexagonal nut of the pressure relief valve or the filter are loose and tighten them. Finally, a defective gasket or O-Ring of the pressure relief valve of the filter might be the issue; replace the gasket and the O-Ring, being careful not to change the calibration of the pump.
Why does the pressure gauge indicate an unacceptable pressure on my LAVAZZA LB 2800?
If the pressure gauge on your LAVAZZA Coffee Maker indicates an unacceptable pressure, the pressure gauge itself may be defective and need replacement. Alternatively, the boiler calibration could be incorrect; adjust the calibration of the boiler.
Why is the coffee cold from my LAVAZZA LB 2800?
If the coffee from your LAVAZZA Coffee Maker is cold, the heating element may be damaged and need replacement. Check for any defects in the electrical connection. Lime scale on the exchangers and/or the heating element can also cause this issue; clean the machine. If the thermostat protecting the heating element is triggered, reset the heating element protection. Lime scale might also have reduced the water circulation; clean the connectors of the exchanger and clean or replace the two circulation pipes. Finally, if the brewing unit is cold, eliminate air pockets in the hydraulic circuit.
General| Capsule System | Lavazza Blue |
|---|---|
| Voltage | 220-240 V |
| Frequency | 50-60 Hz |
| Color | Black |
| Programmable | No |
| Milk Frother | No |
| Number of Cups | 1 |
| Type | Capsule |
| Power | 1200 W |
| Product Type | Espresso Machine |
| Coffee Input | Capsules |
| Dimensions | 14.5 x 26.5 x 31 cm |
To Next Page