Need help?Do you have a question about the LaView LV-D2108CS Series and is the answer not in the manual?
Guides on setting and calling PTZ presets, patrols, and patterns for automated camera movements.
Details how to set stream types, resolutions, bitrates, and quality for recording.
Explains how to set up daily and holiday recording schedules for cameras.
Guides on setting up motion detection areas, sensitivity, and triggering recording.
Describes how to set up redundant recording for enhanced data safety and reliability.
Covers methods to protect recorded files by locking them or setting HDD to read-only.
Explains how to export recorded files using quick export, normal search, and event search.
Guides on configuring motion detection parameters, areas, sensitivity, and alarm actions.
Details how to detect video loss for a channel and configure alarm response actions.
Explains how to detect video tampering and set up alarm response actions.
Covers configuring responses for various system exceptions like HDD errors or network disconnection.
Covers basic network settings like NIC type, IP address, gateway, and DNS server.
Details advanced network configurations including PPPoE, DDNS, NTP, SNMP, UPnP, and remote alarm hosts.
Covers testing network delay, packet loss, and exporting network packets for diagnostics.
Provides steps for initializing a newly installed hard disk drive before use.
Covers adding and configuring NAS or IP SAN disks as network HDDs.
Details how to set up HDD groups and assign channels for recording to specific HDD groups.
Explains how to set HDD property to Redundancy, Read-only, or Read/Write for data safety.
Guides on allocating specific storage quotas for recorded files per camera.
Covers setting up alarms for HDD errors, such as uninitialized or abnormal status.
Explains how to reset the device to factory default settings.
To Next Page
General
