To Next PageTo Next PageWhy Lawn-Boy Lawn Mower engine will not start?
If your Lawn-Boy lawn mower engine won't start, try these steps: First, fill the fuel tank with fresh gasoline. Next, press the primer three times. Ensure the spark plug wire is connected. Finally, clean the spark plug, check its gap, and replace it if it's damaged.
What to do if Lawn-Boy Lawn Mower engine starts hard or loses power?
If your Lawn-Boy lawn mower engine starts hard or loses power, try the following: drain and refill the fuel tank with fresh gasoline, clean the gas cap vent hole, replace the air filter element (if you have models 10200, 10249, 10313, 10321) or clean air filters (if you have models 10248, 10327, 10328, 10330), clean the mower discharge chute and the underside of the mower deck, clean the spark plug (checking the gap and replacing if damaged), and check the engine oil.
How to fix Lawn-Boy Lawn Mower that will not self-propel?
If your Lawn-Boy lawn mower will not self-propel, try adjusting the self-propelled cable and clean any debris under the belt cover.
Why Lawn-Boy Lawn Mower engine runs rough?
If your Lawn-Boy lawn mower engine is running rough, make sure the spark plug wire is connected. Also, clean the spark plug, check the spark plug gap, and replace the spark plug if damaged. Replace the air filter element if you have models 10200, 10249, 10313, or 10321, or clean the air filters if you have models 10248, 10327, 10328, or 10330.
What to do if Lawn-Boy Lawn Mower vibrates excessively?
If your Lawn-Boy lawn mower or engine vibrates excessively, you should: balance the blade, tighten the blade mounting nut, clean the mower discharge chute, clean the underside of the mower deck, and tighten the engine mounting bolts.
Why Lawn-Boy Lawn Mower has uneven cutting pattern?
If your Lawn-Boy lawn mower has an uneven cutting pattern, ensure all four wheels are at the same height. Sharpen and balance the blade. Try changing your mowing pattern and clean the underside of the mower deck.
What to do if Lawn-Boy Lawn Mower discharge chute plugs?
If the discharge chute of your Lawn-Boy lawn mower keeps plugging, try raising the cutting height. Allow the grass to dry before mowing. Also, clean the underside of the mower deck.
General| Brand | Lawn-Boy |
|---|---|
| Model | 10200 |
| Category | Lawn Mower |
| Language | English |
Follow all safety instructions to prevent injury or death when operating the mower.
Check oil level before each use and fill crankcase with SAE 30W oil.
Use fresh, lead-free gasoline (85+ octane); never use methanol or high ethanol blends.
Push primer, hold bail, pull starter cord. Repeat if engine fails to start.
Release the blade control bail to stop both the engine and blade.
Squeeze the self-propelled bail to engage; release to disengage. Adjust speed by bail spacing.
Schedule for fasteners, air filter, engine oil, housing, drive belt, and blade brake checks.
Replace or clean air filter as per schedule or conditions; do not operate without it.
