LawnMaster CLMF4817E - Adjusting Cutting Height

17
ASSEMBLY
Removing the grass collection bag:
1. Lift the rear safety ap and hold it in position.
2. Lift the grass collection bag by its handle, and unhook the grass collection bag from the mower.
3. Release the rear safety ap.
NOTE: Under normal usage, bag material is subject to wear. To reduce the risk of injury, frequently inspect the
collection bag and replace if there are any signs of wear or deterioration.
ADJUSTING THE CUTTING HEIGHT
Do not at any time make any adjustment to the lawn mower without rst stopping the motor and removing the
safety key. Keep your feet away from the mower deck when adjusting its height.
When shipped, the rear wheels on the mower are set to a low-cutting position. Before using the mower for the
rst time, adjust the cutting position to the height best suited for your lawn. The mower can be set to 5 cutting
heights between 1.4" (35 mm) and 3" (75 mm). Choose the proper cutting height according to the types and
conditions of the grass.
To set the cutting height:
1. To raise the cutting height, grasp the cutting height adjustment lever and move it toward the back of
the mower (Fig. 5).
2. To lower the cutting height, grasp the cutting height adjustment lever and move it toward the front of
the mower (Fig. 5).
WARNING
1
2
3
4
5
Fig. 5