LawnMaster CLMF4841E - Page 30

30
TROUBLESHOOTING
Mower does not mulch properly.
Wet grass clippings are sticking
to the underside of the deck.
Wait until the grass dries before
mowing.
Missing mulching plug. Install the mulching plug.
Poor collection performance.
The mowing conditions are not
optimal.
Cut long grass down in stages
by gradually lowering the height
of cut. Wait for wet grass to dry.
Mulching plug is inside
collection chute.
Remove the mulching plug.
Area of cut (battery duration) is
not large enough.
Height of cut is too low.
Increase the height of cut and
walk slower.
The grass is too high.
Increase the height of cut and
walk slower.
The grass is wet or damp.
Wait until the grass is dry and
walk slower.
The grass is dense.
Increase the height of cut, walk
slower and cut more frequently.
The blade fails to rotate.
The blade is blocked by grass.
Switch off the mower and
remove the grass (always wear
gardening gloves).
The blade nut/bolt is loose.
Tighten the blade nut/bolt (25
Nm).
Excessive vibrations/noise.
The blade nut/bolt is loose.
Tighten the blade nut/bolt (25
Nm).
The blade is damaged. Replace the blade.
The motor shaft is bent.
Stop the mower and remove
the isolator key and batteries,
and inspect for damage. Have
repaired made by a qualied
person.
No charging procedure
possible.
The battery contacts are
contaminated.
Clean the battery contacts (e.g.
by inserting and removing the
battery several times) or replace
the battery.
Socket outlet, fuse, mains cable
or battery charger are defective.
Check the mains voltage and
fuse, if necessary, contact
aftersales helpline.
The battery has a fault. Replace the battery.
The charge control LEDs do not
light up after inserting the mains
plug into the socket.
Mains plug of the battery
charger is not plugged in
properly.
Insert mains plug fully into the
socket outlet.
Socket outlet, mains cable or
battery charger are defective.
Check the mains voltage and
if necessary, contact aftersales
helpline.